Geekvape J Series Replacement Coils

Geekvape J Coils

Geekvape J coils are mesh replacement coils for the Digi Max and Digi Pro pod kits. They push-fit into Geekvape J Empty Pod cartridges, so you swap the coil and keep using the same pod rather than replacing the whole thing. Four resistances from 0.4 ohm up to 1.2 ohm, covering RDL and MTL. Sold in packs of five.

Key Features

• Mesh coils in 0.4, 0.6, 0.8, and 1.2 ohm
• Push-fit into Geekvape J Empty Pod cartridges
• Compatible with Digi Max and Digi Pro pod kits
• MTL and RDL coverage across the resistance range
• Works with nic salts and 50/50 e-liquids
• 5-pack quantity

J Coil Resistance and Wattage Guide

The 0.4 ohm runs warmest with more vapour, good for looser RDL draws. At the other end, the 1.2 ohm gives you a tight pull at low wattage, closest to how a cigarette draws. The 0.6 ohm sits in between and handles both MTL and RDL depending on your airflow setting. If you mainly vapenic salts, the 0.8 or 1.2 ohm coils are the ones to go for.

Digi Max and Digi Pro Coil Compatibility

Geekvape J coils fit both the Digi Max and Digi Pro through the J Empty Pod cartridge. You can’t use them without the empty pod – the coil pushes into the pod base, then the pod clicks into the kit. Both devices auto-detect your coil resistance and adjust the wattage through Smart Mode. All four resistances work in both kits.The J coils don’t fit other Geekvape pod systems like the Wenax Q2 or Soul 2. Those use their own pod types with built-in coils.

How to Change a J Coil

Pull the old coil straight out of the J Empty Pod base. Push the new one in until it clicks. Before you fill up, drop a few spots of e-liquid onto the exposed cotton inside the coil to prime it. Fill the pod, then leave it for 5 minutes so the cotton soaks through properly. Skipping the priming step usually means a burnt taste on the first few draws.

Geekvape J Coils Specifications

What’s in the Box?

• 5 x Geekvape J Series Replacement Coils (choose resistance: 0.4, 0.6, 0.8, or 1.2 ohm)